Filter
Top Products
FULL TWOYEAR WARRANTY
Philips Electronics North America Corporation warrants each new
Philips Product,Model HP6414,against defects in materials or work-
manship for a period of two years from the date of purchase, and
agrees to repair or replace any defective product without charge.
IMPORTANT: This warranty does not cover damage resulting
from accident,misuse or abuse,lack of reasonable care,the affixing
of any attachment not provided with the product or loss of parts or
subjecting the product to any but the specified voltage.*
PHILIPS ELECTRONICS NORTH AMERICA CORPORATION
WILL NOT PAY FOR WARRANTY SERVICE PERFORMED
BY A NON-AUTHORIZED REPAIR SERVICE AND WILL
NOT REIMBURSE THE CONSUMER FOR DAMAGE RESULT-
ING FROM WARRANTY SERVICE PERFORMED BY A NON-
AUTHORIZED REPAIR SERVICE.
NO RESPONSIBILITY IS ASSUMED FOR ANY SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES.
In order to obtain warranty service,simply take or ship the product
postage prepaid to the nearest Authorized Norelco Service
Location. It is suggested that for your protection you return ship-
ments of product by insured mail,insurance prepaid.Damage occur-
ring during shipment is not covered by this warranty.
NOTE: No other warranty,written or oral,is authorized by Philips
Electronics North America Corporation.
This warranty gives you specific legal rights,and you may also have
other rights which vary from state to state.Some states do not allow
the exclusion or limitation of incidental or consequential damages,so
the above exclusion and limitations may not apply to you.
* Read enclosed instructions carefully.
Manufactured for:
Norelco Consumer Products Company
A Division of Philips Electronics North America Corporation
1010 Washington Blvd.,Stamford,CT 06912-0015
MADE IN AUSTRIA.
This symbol on the product’s nameplate means it is
listed by Underwriters’ Laboratories,Inc.
PHILIPSand Philips Shield are Registered Trademarks of Philips
Electronics N.V.
Satinelle Sensitive and Sens-Relief are Trademarks of Philips
Electronics North America Corporation.
© 1998 Philips Electronics North America Corporation.
All Rights Reserved.
Maintenance
Instructions
Sens-Relief
System
Intensity Settings
9
10
12
13
11
CLICK
14
• For areas with bones close to the skin’s
surface (knees, ankles),select the normal
intensity.
• For the more fleshy areas (thighs and calves),
select extra intensity (Fig.4 and Fig.5).
4. Keep the skin taut using your fingers to
stretch the skin so the rotating discs can grasp
hairs (Fig. 6).
5. Hold the Satinelle Sensitive System
perpendicular to your leg with the ON/OFF
Switch facing you (Fig.7).
6. Gently press and move the Satinelle System
slowly over the skin against the direction of
hair growth (Fig. 8).If you press too lightly or
too hard,the Satinelle Sensitive System will not
be able to grasp and remove the hairs.
Experiment until you find the right settings and
right amount of pressure for your type of skin
and hair.
7. To switch the System OFF,first slide the Sens-
Relief Control to position “
-” (Fig.9), then slide
the ON/OFF Switch to the “O” position (Fig.10).
NOTE: If you choose to use a cream or moistur-
izing lotion after use, be certain it does not
contain alcohol as it may cause discomfort.
IMPORTANT:
• After using the Satinelle Sensitive System,some
redness or irritation may occur. This is normal
and should disappear quickly.
• This appliance is for dry use on legs only.
• Clean the appliance regularly following
MAINTENANCE instructions.
IMPORTANT
• Always switch the Satinelle Sensitive System to
OFF position “O” and remove plug from elec-
trical outlet before cleaning (Fig.10).
• It is essential for hygienic reasons and
optimum performance that the epilating
head and rotating discs are cleaned after
each use.
• Never immerse this appliance in water,however,
the Sens-Relief element can be removed and
washed or rinsed clean. The Sens-Relief ele-
ment must be air dried thoroughly before
replacing it on the Satinelle Sensitive System.
• Never clean, remove, or replace epilating head
or rotating discs while motor is ON.
The rotating discs are not removable from
the appliance.
• Do not apply pressure or touch rotating discs
with hard objects as this may dent or damage
the discs. If damage occurs,discontinue use
immediately.
• Do not use strong or abrasive cleaners or ace-
tone to clean the housing/body of Satinelle
Sensitive System.
1. Brush the rotating discs clean (Fig.11).
2. Remove Sens-Relief element (Fig.12).
3. Wash the rubber tips of the Sens-Relief ele-
ment using the brush (Fig. 13).
4. Air dry the Sens-Relief element thoroughly and
then replace it on Satinelle Sensitive System
(Fig. 14).
• All servicing should be performed by an
Authorized Norelco Service Location onl
y.
4203 000 44721
Rev.1 8/98