Philips HP4883 Hair Dryer User Manual


 
Important
Read these instructions for use carefully before using the appliance and
save them for future reference.
Check if the voltage indicated on the appliance corresponds to
the local mains voltage before you connect the appliance.
Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the cord or the appliance itself is damaged.
If the mains cord is damaged,it must be replaced by Philips,a
service centre authorised by Philips or similarly qualified persons
in order to avoid a hazard.
Keep this appliance away from water! Do not use this product
near or over water contained in baths, washbasins,sinks etc.
When used in a bathroom,unplug the appliance after use since
the proximity of water presents a risk, even when the hairdryer is
switched off.
For additional protection,we advise you to install a residual
current device (RCD) with a rated residual operating current
not exceeding 30mA in the electrical circuit supplying the
bathroom.Ask your installer for advice.
Keep the appliance out of the reach of children.
Never block the air grilles.
If the appliance overheats, it will switch off automatically. Unplug
the appliance and let it cool down for a few minutes. Before you
switch the appliance on again,check the grilles to make sure they
are not blocked by fluff, hair,etc.
Always switch the appliance off before putting it down,even if it
is only for a moment.
Always unplug the appliance after use.
Do not wind the mains cord round the appliance.
You may notice a characteristic odour when using this hairdryer.
This is caused by the ions that are generated and it is not harmful
to the human body.
Do not probe the ion generator with metal objects.
ENGLISH 7