Filter
Top Products
General description (fig. 1, page 3)
A Sun couch tube lamps
(Cleo Effect 90 W) and starters
(S 11)
B Solarium tube lamps (Cleo Effect 90 W) and starters (S 11)
C Face tanner lamp (type HB 577 only) for extra face
tanning performance
D Switches for face tanner (type HB 577 only)
‚ = face tanner switched off.
A and A = 70% of full intensity.
A and AA = full intensity.
E End caps
F Mains cord
G Timer
H Stand feet
I Stand legs
J Hinge sections (with gas springs)
K Height adjustment holes
L Connecting cord (solarium-sun couch)
M Cooling fans
N Vents
O Protective shields
P Protective plastic foil
Q Protective eye goggles (2x)
(Type HB 072 / service n°. 4822 690 80147)
R Bolts, nuts, plastic studs and caps, socket head
screws
S Spanners, socket head wrench
T Holder for timer
Making the Combi solarium ready for use
With two persons helping you, you can assemble and move
the Combi solarium.
• Please note: For stability it is essential that you position the
sun couch first.
After that you mount the solarium (top mount) (fig. 2).
When disassembling, first remove the solarium (top mount)
and after that remove the sun couch.
• While assembling the Combi solarium will of course grow
heavier and thus more difficult to move.
Assemble the appliance preferably on its definite place.
Allow sufficient space beside (at least 50 cm) and behind (at
least 30 cm) the Combi solarium.
Sun couch
- Assemble the tubes of the
stand using the socket head
screws (fig. 3-5).
Do not screw too tightly.
• Please note that the larger
openings of the tubes face
outwards.
• Ensure that you locate the
notched tube (fig. 4) and the
tube without notches (fig. 5)
properly.
- Fix the covering panels
around the stand (fig. 6a)
using the plastic studs
(fig. 6b).
Please note the correct
fixing order.
• The end panels (2, 4)
should enclose the front and
rear panels (1, 3).
Fit the notches on the end
panels into the apertures of
the stand feet.
• The covering panels are
merely intended to give the
stand a nicer appearance.
- Carefully put the sun couch
on the stand.
Slide the legs into the
corresponding holes (fig. 7).
• Please note: the connecting
cord should be at the rear
side.
- Fix the timer holder to the
stand leg at the head end
side (fig. 8).
6
3
4
✔
2
1
2
5
1
4
2
3
6a 6b
7
8