Filter
Top Products
ENGLISH 19
C 2 Press the razor head release button, open
and lift off the razor head assembly.
C 3 Turn the wheel counterclockwise and
remove the retaining frame.
4 Remove and clean one set of cutters and
combs at a time.
C 5 Separate the cutter from the comb and
rinse clean under hot water.
Do not clean more than one cutter and comb at
a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
C 6 Replace the set back into the Razor Head
Assembly so that the ‘wings’ on the comb
fit within the brackets located towards the
center of the Assembly.
The set will only fit into the Razor Head
Assembly if the ‘wings’ are between the brackets.
Make sure that the two pointy edges of the head
fit exactly into the recesses.
7 Repeat the process for the other two sets
of cutters and combs.
8 Replace the frame.
8825XLDFU8_06_04.qxd 7/9/04 5:01 PM Page 19 (Black plate)