Filter
Top Products
ENGLISH
C 3 Turn the black 3-pronged locking bracket
counterclockwise to unlock (1) and
remove the retaining frame (2).
C 4 Remove and clean one set of cutters and
combs at a time.
C 5 Separate the cutter from the comb and
rinse clean under hot water.
Do not clean more than one cutter and comb
at a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
C 6 Replace the set back into the Razor Head
Assembly so that the ‘wings’ on the comb
fit within the brackets located towards the
center of the Assembly.
The set will only fit into the Razor Head Assembly
if the ‘wings’ are between the brackets. Make sure
that the two pointy edges of the head fit exactly
into the recesses.
20
ENGLISH
7 Repeat the process for the other two sets
of cutters and combs.
8 Replace the frame.
C 9 Press down (1) and turn the black
3-pronged locking bracket clockwise (2)
until it locks into place.
10 Close the Razor Head Assembly.
Once A Month: Razor Head
For optimum performance, razor cutters and
combs should be cleaned in a degreasing liquid
(e.g. rubbing alcohol) and lubricated with one
drop of mineral oil (in the center of the head).
This helps prevent wear of the shaving heads.
After Each Use: Trimmer
1 Turn razor OFF.
C 2 Push down spring-release trimmer switch.
21