Filter
Top Products
12 Repeat the process for the other two
razor heads (cutters and combs).
13 Replace the frame.
C
14 Turn the wheel clockwise until it locks into
place.
C
15 Replace the Razor Head Assembly back on
razor.
16 Put the protective razor head cap on the
razor to protect heads.
After Each Use:Trimmer
1 Turn razor OFF.
C
2 Push Trimmer Slide Switch up to pop up
Trimmer.
C
3 Clean Trimmer with the brush after each
use.
C
4 Lubricate the Trimmer teeth with Norelco
Razor Lubricant (model AL80) or with one
drop of mineral oil every 6 months.
5 Close Trimmer by sliding Trimmer switch
down.
ENGLISH 17
4 Turn Razor Head Assembly over so that
underside is exposed.
C
5 Turn wheel of frame counterclockwise.
6 Remove the frame and brush clean.
C
7 Remove and clean one cutter and comb at
a time.
Do not clean more than one cutter and comb at
a time, since they are all matching sets. If you
accidentallly interchange the cutters and combs it
could take several weeks before optimal shaving
performance is restored.
8 Separate the cutter from the comb.
C
9 Only brush the cutter in an upward
motion. Use the short bristled side of the
brush.
C
10 Brush the razor head.
For optimum performance, razor cutters and
combs should be cleaned in a degreasing liquid
(e.g. Norelco Razor Head Cleaner, model RC1776
or alcohol) and lubricated with Norelco Razor
Lubricant, model AL80, or one drop of mineral oil
(in the center of the head).This helps prevent
wear of the shaving heads.
C
11 Replace the cutter and comb into the
Razor Head Assembly.
ENGLISH16
Downloaded from www.Manualslib.com manuals search engine