Filter
Top Products
14
4 Turn Razor Head Assembly over so that underside is
exposed.
5 Press down and turn wheel of frame counterclockwise.
6 Remove the frame and brush clean.
7 Remove and clean one cutter and head at a time.
• Be careful not to mix up cutters and heads.They are a
matched set and if interchanged,it will greatly affect
shaving performance.
8 Separate the cutter from the head.
9 Only brush the cutter in an upward motion.
Use the short bristled side of the brush.
10 Brush the slots of the razor head.
For optimum performance,razor cutters and heads should
be cleaned in a degreasing liquid (e.g. Norelco Razor
Cleaner, model RC1776 or alcohol) and lubricated with
Norelco Razor Lubricant,model AL80,or one drop of
mineral oil (in the center of the head).