Filter
Top Products
9.8.
2 Press the Razor Head Release Button and remove
Razor Head Assembly from the razor unit.
3 Brush the inside of the razor housing.
4 Turn Razor Head Assembly over so that
underside is exposed.
5 Press down and turn wheel of frame counterclockwise.
6 Remove the frame and brush clean.
7 Remove and clean one cutter and head at a time.
• Be careful not to mix up cutters and heads.They
are a matched set and if interchanged,it will greatly
affect shaving performance.
8 Separate the cutter from the head.
9 Only brush the cutter in an upward motion.
Use the short bristled side of the brush.
10 Brush the slots of the razor head.
For optimum performance, razor cutters and heads
should be cleaned in a degreasing liquid (e.g.Norelco
Razor Cleaner model RC1776 or alcohol) and lubricated
with Norelco Razor Lubricant,model AL80,or one drop
of mineral oil (in the center of the head).
11 Replace the cutter and razor head in the Head Assembly.
12 Repeat the process for the other two razor heads
(cutters and heads).
13 Replace the frame.
14 Press down and turn the wheel clockwise until it locks
into place.
15 Replace the Razor Head Assembly back on razor.
After Each Use:Trimmer
1 Turn razor OFF.
2 Push Trimmer Slide Switch up to pop up Trimmer.
3 Clean Trimmer with the brush after each use.
4 Lubricate the Trimmer teeth with Norelco Razor
Lubricant (model AL80),or with one drop of mineral
oil every 6 months.
5 Close Trimmer by sliding Trimmer switch down.