Filter
Top Products
4. 5.
INSERTING LOTION CARTRIDGE
First Use
1 Take one cartridge from the box.
2 Remove the supplied connector out of the plastic bag.
Push it into the plastic cap of cartridge until you hear it
“click” into place.
3 Slide down latch and lift back cover off razor.
4 Slide the cartridge, with the connector in place, into
position in razor.The connector should slide into the
recess area with hole located at the top of razor.
The white round dot on the connector must face down
towards the razor.
5 Replace back cover on razor and press it down into
position until it snaps shut.
Replacing Used Cartridge
1 Slide down latch and lift back cover off razor.
2 Remove the empty cartridge from the razor and pull
out the connector.DO NOT discard the connector.
INDICATIONS
LED Charging Indicator Light
The green LED Charging Indicator Light will light up to
indicate razor is (re)charging.
CHARGING
Battery performance is best if you recharge only when
the batteries are (almost) completely empty.
Charging or recharging at temperatures below 40ºF or
higher than 95ºF adversely affects lifetime of batteries.
Continuously recharging will reduce life of batteries.
If razor has not been used for at least 1 month, razor must
be recharged for a full 8 hours.
Do not charge razor in pouch.
1 Connect cord to razor. Plug into any 110V to 220V AC
outlet. Use only the cord provided.
An adaptor plug may be necessary for cord usage in some
foreign countries.
2 First time charging and recharging after non-use for 1 month
or more requires a full 8 hours for up to 30 minutes of
cordless shave time.