Filter
Top Products
9.8. 9.
9 Only brush the cutter in an upward motion.
Use the short bristled side of the brush.
10 Brush the slots of the razor head. For optimum
performance, razor cutters and combs should be
cleaned in a degreasing liquid (e.g. Norelco Razor
Cleaner RC1776 or alcohol) and lubricated with
Norelco Razor Lubricant, model AL80, or one
drop of mineral oil (in the center of the head).
11 Replace the cutter and razor head in the Head Assembly.
12 Repeat the process for the other two razor heads
(cutters and combs).
13 Replace the frame.
2 Remove Razor Head Assembly off the razor
unit.
3 Brush the inside of the housing.
4 Turn Razor Head Assembly over so that the
underside is exposed.
5 Press down and turn wheel of frame counterclockwise.
6 Remove the frame and brush clean.
7 Remove and clean one cutter and head at a time.
• Be careful not to mix up cutters and heads.They
are a matched set and if interchanged, it will greatly
affect shaving performance.
8 Separate the cutter from the comb.