Philips 25LC Hair Clippers User Manual


 
9. SHORT CUT
1.Use Hair Clipper with Guide
Comb.
2.Comb hair so that it falls into
its natural direction.
3.Choose desired setting on
Hair Length Selector.
4.Cut hair against direction in
which it grows starting from
the front to crown of head
(Fig. 9).
5.Cut up sides to crown of head
(Fig. 10).
6.Cut up the back to the crown
(Fig. 11).
7.If necessary, repeat this cut-
ting to be certain hair is
uniform in length.
8.For smooth, even cutting,
especially with coarse, heavy
hair, allow Hair Clipper to cut
through hair - do not force it
through hair faster than it
can cut.
9.Finish this cut using the OUT-
LINING method to smooth
out hair line.
8. OUTLINING
Outlining helps to give a
smooth, well-groomed line
along edge of hair.
1.Remove Guide Comb from
Hair Clipper.
2.Comb hair so that it falls into
its natural direction.
3.Hold Hair Clipper over ears
with corner edge of Hair
Clipper against hair line
(Fig. 7).
4.Angle upper edge of Hair
Clipper at a safe distance
from top of ear. Slowly and
carefully follow desired out-
line of hair over and behind
ears and down sides of
neck.
5.For longer hair styles, where
hair is worn over the ears,
use scissors to trim off as
much hair as desired.
6.For defining sideburns and
back of neck, hold Hair
Clipper as shown against the
skin and move it down slow-
ly (Fig. 8).
10. CREW CUT
1.Use Hair Clipper with Guide
Comb.
2.Comb hair so that it falls into
its natural direction.
3.Begin with highest (#7)
setting on One Step Select
Switch.
You may want to adjust this
setting as you become famil-
iar with the settings.
4.Hold Guide Comb flat against
head and slowly move it
through hair.
5.Cut hair up the back to crown
of head.
6.
Cut straight up sides and
from back of ears in a line
even with sides of face.
Leave hair long on top from
the front to the crown
(Fig. 12).
7.To give a “flat top” look, hair
on top of head must be cut
over a comb or between fin-
gers.
8.Lift hair with comb or fingers
to desired length and cut hair
with scissors or with Hair
Clipper without Guide Comb
(Fig. 13).
9.Comb hair and check for
uneven spots. Finish this cut
using the OUTLINING method
for sideburns and neckline.
7
8 10 11 12 13
9