Filter
Top Products
109
Fitting the Blood Pressure Monitor
1. Attaching the cuff to the upper
arm.
•Make sure the cuff is wrapped so
that it is in contact with the skin.
Measurements may be taken
from either the left or right
arm. However, please take
measurements using the same
arm each time, because there
is said to be a blood pressure
difference of approx. 10 mmHg
between the left and right.
2. Fasten firmly, but not too tight.
• Optimally, there should be enough
room to insert one finger between
the cuff and arm.
• Make sure your sleeve does not
get in the cuff.
• Firmly attach using the hook-and-
loop tape.
Positioning on the Upper Left Arm
• Position so that
the tube extends in
line with the little finger
on the palm side.
Wrap the cuff around
the arm 2 to 3 cm
(25/32" to 1-3/16")
above the elbow.
Positioning on the
Upper Right Arm
Inserting/replacing batteries
1. Slide off the Battery Cover
from the housing.
2. Insert four 1.5 V batteries
(R6/AA), ensuring correct
polarity.
3. Close the Battery Cover.
Batteries must be replaced when ...
• The Replace batteries symbol appears on the display.
• You press the ON/OFF/Start Button and the display screen
goes blank after all displays have come on.
• You press the ON/OFF/Start Button and nothing is displayed on the
screen.
Note:
• New batteries contain enough power for about 200 measurements.
• If you do not use the unit for a long time, we recommend to remove
batteries from the main unit to avoid damage by liquid leakage.
• Low temperature conditions can cause battery life to be shortened.
1
3
2
CAUTION:
Do not throw batteries into a fire. Doing so may result in an accident or
explosion.
–
+
+
–