Filter
Top Products
5
English
Reading the LCD panel when charging
The LCD panel shows the remaining battery capacity from 0% to
100%, in 10% increments.
While charging After charging is completed
The indicators glow.
Battery capacity and Charge status
will light up and then turn off after 5
seconds.
After charging is completed, turning the power switch ON with
the shaver plugged in will cause Battery capacity and Charge
status to light up and then turn off after 5 seconds. This shows
that the shaver is fully charged.
Recommended ambient temperature f
or charging is 5‑35 °C
(41‑95 °F). The battery may not charge properly or not at all
under extreme low or high temperatures.
The indicators on the LCD panel blink when there is a problem
with charging.
When charging the shaver for the first time or when it has not
been in use for more than 6 months, the indicators on the LCD
panel may not glow. It will eventually glow if kept connected.
•
•
•
Shave
Using the shaver
1
1
Rotate the lock ring to
unlock the power switch
and press the power
switch.
Page 4
2
2
Hold the shaver
as illustrated
above and shave.
We recommend using the shaver in an ambient temperature
range of 5 ‑ 35 °C (41 ‑ 95 °F). If used outside this range, the
appliance may stop operating.
Start out shaving by applying gentle pressure to your face.
Stretch your skin with your free hand and move the shaver back
and forth in the direction of your beard. You may gently increase
the amount of pressure as your skin becomes accustomed to
this shaver. Applying excessive pressure does not provide a
closer shave.
Caution
If you press the power switch for more than 2 seconds, the
sonic vibration cleaning mode is activated.
Page 7
You cannot shave in this mode.
Do not place your fingers on the power switch while using the
shaver. This may cause the shaver to turn off or enter the sonic
vibration cleaning mode. Place your thumb on the thumb rest
while using the shaver.
•
•
•