Filter
Top Products
6
c
d
e
f
b
a
g
h
i
11
7
Before use
This Wet/Dry shaver can be used for
wet shaving with shaving lather or for
dry shaving. You can use this water-
tight shaver in the shower and clean
it in water. Treat yourself to wet lather
shaves for at least three weeks and
notice the difference. Your Panasonic
Wet/Dry shaver requires a little time
to get used to because your skin and
beard need about a month to adjust
to any new shaving method.
Charge the shaver for at least 8 hours
before using it for the first time or
when it has not been in use for more
than 6 months.
Parts identification
(see fig. 1)
A Protective cap
B System outer foil
C Inner blades
D System outer foil release buttons
E Pivot action selector
F-a Battery capacity monitor
F-b Low battery indicator
G Charge status lamp
H On/Off switch
I Trimmer
J Trimmer handle
K Adaptor
L Power cord
M Charging stand
READ ALL INSTRUCTIONS BE-
FORE USE.
Charging
Connect the power cord to the
shaver, and plug the adaptor to an
AC outlet. (see fig. 1 (A))
It will adjust automatically to voltages
between 100-240V AC.
In some areas, a special plug adap-
tor may be required.
The charge status lamp will glow when
the shaver is being charged. It will
flash when the charging is completed.
(For ES8152, see fig. 2)
While charging, the battery capacity
monitor will display the charge con-
dition (see fig. 2 (A)).
The battery capacity monitor will turn
off in about 10 minutes after the
charging has been completed (100%
level) (see fig. 2 (B)).
You can fully charge the shaver in 1
hour if the battery capacity monitor
flashes down to the 20% level.
(For ES8151, see fig. 3)
You can fully charge the shaver in 1
hour if the low battery indicator
flashes green (see fig. 3 (A)).
A full charge will supply enough
power for approx. 14 shaves (3 min-
utes per shave for a normal beard).
Before travelling, charge it fully for 1
hour if you will not be taking the adap-
tor with you.
In case your shaver is without charge,
you may quick charge it for 1 shave
in about 5 minutes.
7