Filter
Top Products
8
English
Cleaning the shaver
1
2
1
1
Insert the appliance
plug.
2
2
Plug in the adaptor.
Remove any soap or water on
the shaver if it has been
washed with hand soap or
any other detergent.
•
3
3
Remove the
protective cap
and
then attach the
shaver.
Turn the shaver off before
attaching.
Check that the outer foil is not
deformed or damaged when
you are attaching the shaver.
•
•
4
4
Press [SELECT] to select the course.
Each time you press [SELECT], the course changes from “Clean/
Dry/Charge” “Clean/Dry” “Dry/Charge” “Dry” “Charge”.
The courses start approximately 6 seconds after they are
selected.
The course will be aborted if the power is cut off. In this case,
perform the course again from the beginning.
Do not detach the detergent cartridge or the water tank as the
cleaning liquid may spill causing a malfunction.
•
•
•
•
Course
Course selection indications
On shaver
Course completion summary
On recharger
Changeable course
halfway through
On recharger On shaver
Time required
(guide)
[In the low
temperature]
CLEAN DRY
CHARGE
CLEAN DRY
CHARGE
1Charge
*
2345
Glows
Blinks 1 hour
2 Clean/Dry/
Charge
3
Glows while
charging
Blinks 2 hours [+30 min]
3Clean/Dry 2
–
– 1 hour [+30 min]
4Dry/Charge 235
Glows while
charging
Blinks 2 h 40 min
5Dry 234
–
– 1 h 40 min
*The lamp goes out in 6 seconds.
1
ES8109_USA.indb 8 2007/07/25 13:23:20