Filter
Top Products
7
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE (IN
USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE
AT 1-800-338-0552.
Specifications
Power source: 3.0 V DC
(Two “AA” alkaline batteries, not in-
cluded)
This product is intended for house-
hold use only.
shaving head is clogged with foam,
simply rinse it under running water.
Cleaning your shaver
(see fig. 4)
For cleanliness and convenience, we
recommend that you clean your
shaver with water and a liquid hand
soap. Regular cleaning will keep your
shaver in good condition while pre-
venting odors or bacteria from devel-
oping, and maintain the cutting per-
formance.
With the outer foil in place, apply
some hand soap onto the outer foil.
Turn the shaver on and pour some
water over the outer foil.
After about 10-20 seconds, turn the
shaver off.
Remove the foil frame and clean it
with running water.
Wipe off any moisture from the
shaver with a dry cloth and remove
the protective cap to allow the outer
foil to dry completely.
Replacing shaving head
components
It is recommended that you replace
the outer foil at least every year and
the inner blade at least every two
years to maintain your shaver’s cut-
ting performance.
Replacing the outer foil
(see fig. 5)
Squeeze the outer foil release but-
tons and lift the outer foil upward to
remove it. To insert the new outer foil,
press down until it snaps into place.
Replacing the inner blades
(see fig. 6)
Press the foil frame release button
and remove the foil frame. Remove
the inner blade one at a time by
grasping it firmly at both ends and
pulling straight away from the shaver.
To insert the new inner blades, hold
the blade one at a time at both ends
and press downward until it snaps
into the shaver.
Caution
• The outer foil is very thin. If han-
dled improperly, it can be easily
damaged. To avoid personal injury,
do not use the shaver if it has a
damaged foil or inner blade.
• Always check the outer foil and in-
ner blades for damage before use.
• Always replace protective cap af-
ter use.
• Do not take the housing apart as
this can affect the watertight con-
struction.
• If the shaver is not used for a long
time, remove the batteries to pre-
vent possible leakage.
• Do not use new battery with old one
as the battery’s life is reduced.
• Close supervision is necessary
when this shaver is used by, on or
near children or invalids.
• Never drop or insert any object into
any opening.
• Do not use outdoors or operate
where aerosol (spray) products are
being used or where oxygen is be-
ing administered.
76