Filter
Top Products
9
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE (IN
USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT
1-800-338-0552.
FOR CANADA, PLEASE CONTACT ONE OF THE SALES BRANCHES
MENTIONED ON THE BACK PAGE.
Specifications
Power source: 100-120V AC, 50-
60 Hz
Motor voltage: 1.2 V DC
Charging time: 8 Hours
This product is intended for house-
hold use only.
READ ALL INSTRUCTIONS
BEFORE USE.
9
8
How to remove the built-in
rechargeable battery (s) before
disposal of the shaver
(see fig. 8)
The battery (s) in this shaver is not
intended to be replaced by consum-
ers. However, the battery (s) may be
replaced at an authorized service
center. The procedure described be-
low is intended only for removal of
the rechargeable battery (s) for the
purpose of proper disposal.
WARNING:
Do not attempt to replace the bat-
tery (s) for the purpose of reusing
the shaver. This could result in the
risk of fire or electric shock.
1. Remove the protective cap, outer
foil frame and inner blades.
2. Remove the 2 screws (a) on the
top.
3. Grasp the bottom of the unit and
the button area (b) located on the
left and right, and pull the button
area away from the main unit.
4. Remove the 2 screws (c) located
inside the main unit’s case.
5. Grasp the top part (d) and bot-
tom part (e) of the main unit, and
pull them both out.
6. Remove the battery (f) from the
chassis.
Caution
• Do not charge the shaver where the
temperature is below 0°C (32°F) or
above 40°C (104°F), where it will
be exposed to direct sunlight or a
heat source, or where there is a lot
of moisture.
• Use only the included shaver
charging adaptor RE3-98 to charge
the ES4025/ES4026/ES4027
shaver.
• Dry the shaver completely before
setting it in the charging adaptor.
• Keep the charging adaptor away
from water and handle it only with
dry hands. Do not use an extension
cord to connect the charging adap-
tor to an outlet.
• The shaver may not immediately
begin to charge after being placed
into the charging adaptor after use.
Allow the shaver to sit in the charg-
ing adaptor for a few minutes and
check again to make sure that it is
being charged.
• The outer foil is very thin. If han-
dled improperly, it can be easily
damaged. To avoid personal injury,
do not use the shaver if it has a
damaged foil or inner blades.
• Wash the shaver in tap water. Do
not use salt water or boiling water.
Also, do not use cleaning products
that are designed for toilets, bath-
rooms or kitchen appliances. Do
not submerge the shaver for a long
time.
• Do not wipe any part of the shaver
with thinner, benzine or alcohol.
Clean it by using a cloth dampened
with soapy water.
• Do not take the housing apart as
this can affect the watertight
construction.
• This power unit is intended to be
correctly oriented in a vertical or
floor mount position.
8