Oregon Scientific RAR232 Thermometer User Manual


 
EN
10
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
FCC :
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer of an experienced radio/TV
technician for help.
Power
Main unit: 2 x UM-4 (AAA) 1.5V
batteries
Remote sensor unit: 2 x UM-3 (AA) 1.5V
batteries
For best results, use lithium ion batteries in the
remote sensing unit if the outdoor temperature falls below
41°F (-5°C), other battery types will not function at such low
temperatures.
ABOUT OREGON SCIENTIFIC
Visit our website (www.oregonscientific.com) to learn more
about other Oregon Scientific TM products such as digital
cameras, projection clocks, health and fitness gear, and
weather stations. The website also includes contact
information for our customer service department, in case
you need to reach us.
NOTE ON COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must
accept any interference received, including interference that
may cause undesired operations.
NOTE
RAR232A-E CP5.P65 10/4/05, 11:29 AM10