Filter
Top Products
Figure 7
ASSEMBLY INSTRUCTIONS
6
ASSEMBLY INSTRUCTIONS
Floor Stand Kit (for models 11-685 and 11-685NL)
1. Insert each of the five (5) wheel casters into each of the five (5) legs
of the five-legged base (Figure 6).
2. Insert the larger diameter chrome plated pole into the top of the
five-legged base.
3. Insert the large hex-bolt, the large washer, and one small washer from
the bottom center of the five-legged base into the bottom center
of the larger diameter chrome plated pole. Securely tighten the hex bolt.
4. Insert the smaller diameter chrome plated pole into the top of the larger
diameter pole. Insert the black knob into the top of the larger diameter
pole. Set the smaller diameter pole to the desired height and tighten
the black knob.
5. The floor stand is now complete. To attach the Omron Aneroid to the floor
stand, begin by removing the wing nut connecting the aneroid to the
wall-mount bracket (Figure 7).
6. Insert the small hex nut from the Omron Aneroid and one small washer
from the top of the hole where the wing nut was removed.
7. While holding the aneroid and small hex nut assembly in one hand, insert
the small hex nut into the top of the smaller diameter chrome plated pole.
Turn the pole counter-clockwise to attach both assemblies.
Securely tighten the assembly.
8. The floor-mounted Omron Aneroid is now ready for use.
On-Site Calibration:
1. Remove the coiled tube from the connector on the underside
of the aneroid.
2. Insert the calibration tool (or small flat-head screw driver) into the connector
(from where the coiled tube was removed).
3. Turn the calibration tool until the needle on the front of the gauge is centered
at the bottom of the gauge.
Figure 6
7
240
240
220
180
160
140
120
100
80
60
40
20
260
280
300
mmHg
SPHYGMOMANOMETER
CERTIFIED
MADE IN JAPAN
Sphygmomanometer
Five-Legged Base
Large Washer
Small Washer
Large Hex Bolt
Wheel Casters
Small Diameter
Chrome-Plated Pole
Large Diameter
Chrome-Plated Pole
Black Knob
11-675685/IM/3381 Quark4 7/12/02 2:54 PM Page 6