Filter
Top Products
SpecificationsInstalling the Booster with the
Optional Power Injector
Note: As noted in the illustration below, be sure to disconnect the DC power adapter from the
ANT24BNA Booster for 802.11b, and connect it to the NETGEAR ANT24BDC Power Injector.
7
6
Description
26.5 dBm minimum
Frequency Range
Operating Mode
DC Surge Protection
Current Drain (TDD Mode)
Transmit Power
+ 5 dBm minimum
Transmit Input Power
2400 to 2500 MHz
TDD Burst Mode
600 Watts TVS @ 6VDC
700 mA type. @ 6VDC
NETGEAR 500mW Bi-directional
Booster for 802.11b, with Two
Female Reverse SMA Connectors
3 µs maximum
Transmit Ramp Up Time
10 dB typical
Receiver Gain
±1 dB over operating range
Receiver Frequency Response
5 dB maximum
Receiver Noise Figure
3 µs maximum
Receiver Ramp Down Time
ABS
Material
White
Color
130 x 75 x 37 mm (5.1 x 3.0 x 1.5 in)
Device Size (l x w x h)
5.0 g/1.1 lbs (including DC adapter)
Weight
SMA female reverse (2x), 1 for connection to antenna,
1 for connection to ME103 wireless access point
RF Connector Type
50 ± 5 Ohms
RF Connector Impedance
750 VRMS maximum
RF Connector Dielectric
Withstanding Voltage
0.2 dB
RF Connector Insertion Loss
ETHERNET
RESET
5-12V DC
Wireless unit
NETGEAR Antenna
cable (medium or long)
NETGEAR
Antenna cable
(short or medium)
Connect
Antenna
cable
500 mW Booster ANT24BNA
NETGEAR
Antenna
cable (short)
Antenna
e. g. NETGEAR
ANT24O5
Connect
Antenna
cable
Connect
Antenna
cable
Do NOT connect
DC cable
Connect
Antenna
cable
SecondaryPrimary
Current antenna
Do NOT remove
DC Block NETGEAR
Connect
DC cable
Connect
Antenna
cable
Injector NETGEAR
ANT24BDC