Filter
Top Products
PAGE 20 — J-SERIES WALK-BEHIND POWER TROWEL— OPERATION AND PARTS MANUAL — REV. #6 (09/30/10)
J-SERIES TROWEL — ASSEMBLY AND INSTALLATION
3. Remove one brass set nut from the Quick Pitch™ cable
end as shown in Figure 7.
4. Thread the second brass set nut towards the cable as far
as possible.
Figure 7. Quick Pitch™ Cable
5. Insert the cable end through the yoke eyelet (Figure 8)
Tighten the first brass set nut by hand to remove all the
slack from the cable.
6 Using a wrench, tighten the second brass set nut up against
the yoke boss. This will lock the cable in place.
7. Use a wrench and finish tightening the first brass set nut up
against the yoke boss.
Pre-load Adjustment (Quick Pitch™ Models Only)
1. After the Quick Pitch™ handle has been installed on the
trowel, spring pre-load adjustment will be required.
2. Locate the adjustment screw on the underside of the handle
tube (Figure 9).
Figure 9. Cable/Yoke Attachment
Figure 8. Cable Yoke Attachment
Throttle Cable Installation (Honda Engine)
1. Set the
throttle lever
(Figure 10) to the idle position by
pushing it away from the operator’s position towards the
engine.
Figure 10. Throttle Lever
3. A
decal
has been placed on the side of the handle tube to
assist the user in the adjustment of the spring.
4. Align the
arrow
on the adjustment screw with the letter "J"
COMBO
on the
decal
. The letter "J" stands for J-Series
Walk-Behind trowel.
5. Test the pitch control operation and adjust if necessary.