Filter
Top Products
Retro 1800w Dryer
Using your hairdryer
After washing your hair, it’s really
important to prepare it for styling.
If you use lots of heated styling tools
on your hair, try to use a heat
protection spray before you begin
styling. Always dry the excess water
from your hair using a towel, then
use a widetooth comb to detangle
and smooth your hair.
To begin drying, remove the nozzle
from your dryer and blast your hair
with the dryer on the highest speed
setting until your hair is 50% dry –
there is no point trying to style your
hair until it is almost dry. As your
hair begins to dry, switch off your
dryer and attach the concentrator
nozzle. The nozzle must only be
used with low and medium heat
settings. Using the nozzle helps to
direct the airflow and will give your
hair a sleek and smooth finish. If you
are blow-drying curly hair into a
straight style, use the nozzle to direct
air down the shaft of the hair. If you
want to create volume instead, tip
your head upside down and use your
fingers to comb your hair through
as you dry it.
As your hair dries, use the dryer
on a slower speed setting so as not
to blow your style out of place.
When you have achieved the style
you want and your hair is thoroughly
dry, press the ‘Cool Shot’ button for
a blast of cold air to set your style in
place. To switch Cool Shot off and
continue drying with hot air, press
in ‘Cool Shot’ button again.
Don’t forget – to switch off your
hair dryer and store it when you
have finished drying. If you want
to store your hair dryer in the gift
box, always make sure the hair
dryer has cooled down.
Wiring
This product is fitted with a 13 amp
(BS1363) plug. A 13 amp fuse
(BS1362) must be used. If the
socket outlets in your home are
not suitable for the plug supplied
with this appliance, the plug should
be removed and the appropriate
one fitted.
WARNING: The plug
removed from the mains
lead, if severed, must be
destroyed as a plug with
bared flexible cord is
hazardous if engaged
into a live socket outlet.
Mains lead
As a safety precaution and
to prolong the life of your
appliance, do not wrap the
mains lead around the
appliance as this can
cause damage.
Safety information
When using your hairdryer,
basic safety precautions
should always be followed.
Please read these instructions
carefully before using the
product and keep them in a
safe place for future reference.
1 Use this appliance for its intended
use only.
2 To protect against the risk of electric
shock, do not immerse the appliance
in water or in any other liquids.
3 This appliance is not intended for use
by children or other persons without
assistance or supervision, if their
physical, sensory or mental capabilities
prevent them from using it safely. Keep
out of reach of children at all times.
4 Always unplug the appliance when
it is not in use.
5 Do not leave the appliance switched
on while unattended.
6 Check that the voltage on the rating
plate of the hair dryer corresponds with
your house electricity supply which must
be AC (alternating current).
7 In the event of cable damage, do not
attempt to replace the mains cable –
return to Morphy Richards.
8 After use, do not store until the product
has cooled down.
9 For UK only - Do not take this
product into a bathroom or use near
a water basin or any other vessels
containing water.
For other European countries – For
additional protection, the installation
of a residual current device (RCD)
having rated residual operation current
not exceeding 30mA is advised in the
electrical circuit supplying the bathroom.
Ask your installer for advice. When the
hairdryer is used in a bathroom, unplug
it after use as the proximity of water
presents a hazard when the hairdryer
is switched off.