Mitsubishi Electronics -QS90SR2SN-CC Mobility Aid User Manual


 
5 - 9
5.2 CC-Link Safety Relay Module
5.2.1 Start-up procedures
5
SETTINGS AND PROCEDURES BEFORE
OPERATION
5.2 CC-Link Safety Relay Module
5.2.1 Start-up procedures
Figure 5.7 shows start-up procedures for the CC-Link safety relay module.
Figure 5.7 Start-up procedures (1/2)
* 1: Refer to Section 5.3
Yes
No
Start
Install the modules to a control panel
or machine.
Set the extension module station
number and extension communication
terminating resistor setting switch.
*1
Connect the main module and an
extension module with a safety circuit
part extension cable.
*1
Mount a master module, local
module, and standby master module
on the base unit.
Connect the main module with
CC-Link dedicated cable and connect
terminating resistor to both ends of
the module.
Connect
an extension module?
Connect the monitor part (EA, EB, EG,
EP) with shielded cable.
Connect a safety part terminating
connector to the last module.
Set start-up mode with start-up mode
setting switch.
(To next page)