Filter
Top Products
6
Maintenance
To keep your Informer-Mate
™
control unit in good condition:
• Do not immerse the control unit in liquid of any type. The control
unit will not operate properly if exposed to excessive liquids. If the
control unit is immersed in liquid, discard it immediately.
• Gently clean the Informer-Mate
™
control unit with non-caustic
cleaning agents.
• Test your Informer-Mate
™
control unit and sensor pad before each
use and inspect the cords, controls and sensor pads for signs of
damage. Replace any components with signs of wear or damage
immediately. Never use equipment that has been damaged.
• Call your distributor or Micro-Tech at 800-206-1045 to order
replacement parts.
To keep your sensor pads in good condition:
• Do not immerse the pressure pad in liquid of any type. The
pressure pads will not operate properly if exposed to excessive
liquids. If the pad is immersed in liquid, discard it immediately.
• Clean soiled areas of sensor pad with a clean cloth and water or a
vinyl-tolerant solution.
• Keep the pressure pad flat at all times. Folding the pad will damage
it. Do not use the pad if it has been folded.
• Call your distributor or Micro-Tech at 800-206-1045 to order
replacement parts.