Filter
Top Products
Safety advice and cautions
-Read these instructions carefully before switching
on the appliance and keep them for future consul-
tation.
-This appliance is only for domestic use, not
industrial use.
-Do not leave the appliace connected and
unattended when not in use.
Moreover, this will allow saving energy and
extending the life of the appliance.
-Do not leave the appliance within the reach of
children or disabled individuals.
-Before connecting the appliance to the mains,
check that the voltage indicated on the nameplate
coincides with the mains voltage.
-Do not use the appliance near the shower, bath or
other containers holding water.
-Before picking up the appliance after falling into
water disconnect it immediately.
-Do not use the appliance on wet hair,
-Do not use the appliance if the cable or plug are
damaged, or if not functioning correctly.
-Keep the cable away from hot surfaces.
-Do not strecth, bend or warp the cable round the
appliance.
-Do not throw or insert anything into any of the
appliance's cavaties.
-Do not leave the appliance switched on top of any
surface.
-Do not use the appliance where aerosols are in
use.
-Do not position the hot parts of the appliance on
heat-sensitive surfaces.
-The applaince heats when in operation. Do not
bring the hot parts into contact with the skin to
avoid burns.
-Never leave the appliance connected to the
socket.
-Never put the appliance away when it is still hot or
connected.
-No liablility is accepted for damage caused
through inappropriate handling or use other than
that stipulated in this manual.
-Never wrap the cable around the appliance when
it is still hot.
Instructions for use
-Connect the appliance to a socket. This is a mul-
tivoltage appliance, it can therefore be used in any
part of the world (from 110V to 230V).
-Operate the start/stop switch.
-Select the desired temperature using the tempera-
ture control (110°C min - 200°C max).
-The pilot light will come on indicating that the ap-
pliance is heating up.
The hair straightener has a built-in ceramic PTC
system to keep the temperature of the ceramic
plates constant.
-In order to straighten the hair perfectly, take a
strand which is not too thick.
-Starting at the root, place it between the plates in a
perpendicular position and gently pull downwards
until reaching the ends of the strand. If necessary
repeat this action various times.
-Apply the same technique to the rest of the hair.
-When finished, disconnect the appliance by put-
ting the switch in the stop position and unplug it
from the socket.
Cleaning
-Disconnect the aplliance from the mains and leave
to cool before proceeding to clean.
-Clean the appliance with a damp cloth and dry af-
terwards.
-Never submerge the appliance in water or any
other liquid or put it under running water.
-Do not use solvents or abrasive products for
cleaning.
Problems and Solutions
Should the mains connection fail, do not try to re-
place it since this is potentially dangerous. Take
the appliance to an authorised Technical Support
Service. The same applies to any other type of
problem.
This appliance complies with the Low Voltage Di-
rective 73/23/EEC and with Electromagnetic Com-
patibility Directive 89/336 EEC.
WB20310_HAIRSTRAIGHTENER_IM.indd 3WB20310_HAIRSTRAIGHTENER_IM.indd 3 6/3/2010 11:51:26 AM6/3/2010 11:51:26 AM