Mellerware WB201302000W Hair Dryer User Manual


 
- Unplug the appliance from the mains.
Thermal Safety Protector
- The appliance has a safety trip switch that pro-
tects the appliance from overheating.
Cleaning
- Unplug the appliance from the mains and let it
cool before starting any cleaning.
- Clean the electrical appliance and cable with a
damp cloth and dry them afterwards.
NEVER SUBMERGE IN WATER OR ANY OTH-
ER LIQUIDS.
- Clean the equipment with a damp cloth with a
few drops of washingup liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- Do not let water or other liquid enter through
the air holes to avoid damage in the operative
interior parts of the appliance.
- It is very important to maintain the extractable
filter (D) as well as the interior grille clean.
- To clean the interior grille take off the extract-
able filter (D) turning it lightly in an anti clockwise
direction (Fig 1).
- Once cleaning has finished place the grille in
its original position by fitting the three tabs in the
three slots situated on both sides of the grille
while turning lightly in a clockwise direction.
Anomalies and repair
- Take the appliance to an authorised technical
support service if problems arise. Do not try to
dismantle or repair without assistance, as this
may be dangerous.
- If the connection to the mains has been dam-
aged, it must be replaced and you should pro-
ceed as you would in the case of damage.
WB_20130 PRO 2000_IM.indd 4WB_20130 PRO 2000_IM.indd 4 5/3/2010 1:32:33 PM5/3/2010 1:32:33 PM