Filter
Top Products
3
3
- The unit can operate for about 25 mins. after full charge.
For charging the hairtrimmer, press the unit into the charger until
the light indicator ignites. Be sure that the charger is connected to
the outlet.
DIRECT-POWERED BY ADAPTOR
- The proclipper can also be powered directly by the adapter.
- Plug the power feed plug of adapter direct into the unit socket.
Then plug the adapter to the proper AC outlet.
- Do not operate for more than 25 mins. continuously. Allow the
unit to rest for approx. 10 mins. and oil the blades after every
25 mins. of operation, in order to maintain efficient cutting
performance.
- If the clipper should not run immediately due to a completely
empty cell, recharge the trimmer for approx. 1 minute before
cord operation.
OIL BEFORE USING
- Always oil before and after use. Cutting performance deterio
-
rates if cutting blades are not oiled properly. When doing more
than one haircut in one session, clean and oil blades once after
finishing each cut.
- Remove cutting head in direction of arrow.
- Apply about 1 to 2 drops of accessory oil at the cutting blades.
- Slide back the cutting head to the unit.
- Allow the unit to operate without actual cutting for about 10
seconds and wipe off any excess oil.
- The oil contains kerosene and is extremely dangerous if swal-
lowed. Keep the oil away from children.
- Do no use hair-oil or hair-vax.
CONNECTION AND ADJUSTMENT OF ATTACHMENT COMB
- The attachment comb has 6-position adjustment, which provi
-
des 7,10,13,16,18 and 21 mm. cutting length.
- The comb is fixed to the clipper by 2 locks at both sides of the
guide groove of attachment.
- Push attachment knob upward with finger to set the desired
cutting length as shown in the figure.
- Press on comb portion of attachment to make sure that it is
locked to the body.
INSTRUCTIONS FOR HAIR CUTTING
- Inspect the clipper, making sure that it is free of oil between
the cutting blade teeth and turn the unit on to distribute the oil
and to make sure it is running smoothly. Wipe of any excess
oil. This should be done after each use. While using the unit,
untwist the cord from time to time to avoid tangling.
- Seat the person so his/her head is approximately at your eye
level. This allows ease of visibility while cutting and a relaxed
control of the unit.
- Before cutting, always first comb the hair so it is tangle free
and as it is naturally worn.
- Place a towel around the neck and shoulders of the person
having the haircut.