Filter
Top Products
- For a longer cut, use the comb that accompanies the trimmer to lift
the hair on the top of the head. Then let the trimmer pass over the
comb to cut the hair to the desired length. You can also use your
fingers for this. Always work from the back forwards. You can cut
the hair shorter by altering the distance from the scalp to the
comb/your fingers. Comb any loose hair out, and check to see if
there are any uneven sections.
Step 5
- Finally, use the trimmer without attaching a guide comb for a closer
cut around the base and sides of the neck and ears.
-To achieve an even cut around the sideburns, turn the trimmer
over. Press the trimmer gently and steadily against the skin and run
it downwards to achieve a result similar to that of a razor.
Short cuts
- Using the longest guide comb, start at the base of the neck and
then work up towards the crown. Hold the guide comb down flat
against the scalp and work slowly through the hair.
- When cutting the sides, use the same procedure as for the neck.
-To achieve a ‘flat top’ look, cut the hair on the top of the head using
a comb instead of a guide comb.
- Use a shorter guide comb for shorter hair at the sides and on the
neck. Comb the hair and check to see if there are any uneven
sections.
CLEANING
The trimmers can be rinsed under running water.
Always keep the trimmers in a dry place.
The blades can be removed for easy cleaning.
THE GUARANTEE DOES NOT APPLY
- If the instructions given above are not observed.
- If the device has been mishandled, subjected to rough treatment or
has suffered any other form of damage.
- If the device has been subject to unauthorised repairs.
ENVIRONMENTAL TIPS
Once any electrical or electronic product is no longer functional, it
should be disposed of in such a way as to cause minimum
environmental damage. The device should be disposed of in
accordance with the applicable regulations of your local authority. In
most cases you can take such products to your local recycling station.
20
638130_IM_nooil 04/11/04 9:04 Side 20