14 15
14 15
o Always use a low temperature
when using the appliance for
the rst time.
o For thick, frizzy or curly hair use
the temperature settings 13-25
(155-210 °C).
o For ne or ordinary hair,
or softly curled hair use the
temperature settings 1-12 (100-
150 °C).
5. Use the appliance to set your hair
as desired.
6. Switch off the appliance by
pushing the on/off button to “off”
and remove the plug from the
mains.
7. Always allow it to cool completely
before you clean it or put it away.
The appliance can be hanged in
the hanging loop (8).
Styling tips
Brush hair thoroughly before setting.
Divide your hair up into small sections,
and straighten them separately piece
by piece as described below until
the desired result is achieved. Hair
should be clean and dry before using
the appliance. Do not apply styling
products when using the appliance
and take care not to touch the scalp
with the hot appliance.
• Divide the hair into sections where
necessary, and straighten the
bottom layer rst.
• Start with a lock of hair about 3-4
cm wide and close the ceramic
plates around the hair near the
scalp. Turn the appliance so that
the protective plates (2) face up
and the ceramic hotplates face
down.
• Slowly slide the appliance
towards the hair ends in one
uent movement. Ensure that the
ceramic hotplates touch the hair
before the protective plates.
• Repeat after approx. 20 seconds
until the required result is
achieved.
• - Allow the hair to cool completely.
Do not brush or comb the hair until
the hair has completely cooled
as otherwise the hairstyle may be
ruined.
Caution!
• The appliance is supplied with
protective plates of white marble,
which protect the hair against the
heat. The marble plates absorb
excess heat immediately after the
straightening thus letting the hair
cool off quickly.
• The surface of the ceramic plates
will be worn in time. This is not a
aw, and the appliance will still
work correctly.
• If the appliance is used in dyed
hair, the protective plates may be
discoloured. This is not a aw,
and the appliance will still work
correctly.
CLEANING
• Remove plug from the mains
socket, and allow the appliance to
cool down before cleaning it.
• Never submerge the appliance
in water, and no water must be
allowed to get into it.
• Clean the appliance by wiping
it with a damp cloth. A little
detergent can be added if the
appliance is heavily soiled.
• Do not use scouring pads, steel
wool or any form of strong solvents
or abrasive cleaning agents to
clean the appliance, as they may
damage the outside surfaces of
the appliance.
INFORMATION ON DISPOSAL AND
RECYCLING OF THIS PRODUCT
Please note that this Adexi product is
marked with this symbol:
This means that this product must not
be disposed of together with ordinary
household waste, as electrical and
electronic waste must be disposed of
separately.