Filter
Top Products
10 11
10 11
INTRODUCTION
To get the best out of your new appliance,
please read this user guide carefully before
using it for the rst time. Take particular
note of the safety precautions. We also
recommend that you keep the instructions
for future reference, so that you can remind
yourself of the functions of your appliance.
SAFETY MEASURES
Normal use of the appliance
• Incorrect use of this appliance may
cause personal injury and damage to
the appliance.
• Use for its intended purpose only. The
manufacturer is not responsible for
any injury or damage resulting from
incorrect use or handling (see also
Guarantee Terms).
• For connection to 230 V, 50 Hz only.
The appliance must be earthed.
• For domestic use only. Not for outdoor
or commercial use.
• The appliance does not have an on/off
button. Therefore, always remove the
plug from the socket once you have
nished using the appliance.
• Please note that the appliance will
remain hot for a while after you switch
it off. Always allow it to cool completely
before you put it away or clean it.
• If you put the appliance down, always
place it on heat resistant surface
and keep it at a safe distance from
ammable objects such as curtains,
tablecloths or the like.
• Do not place or store near other heat
sources or in a damp environment.
• Do not cover.
• Never submerge the appliance in water,
and no water must be allowed to get
into it.
• Never leave unattended when in use,
and keep an eye on children.
• Caution! The plates get very hot. They
must not come into contact with the
skin, as this can cause burns.
Cord, plug and mains socket
• Keep cord away from hot objects and
open ame.
• Check that it is not possible to pull or
trip over the cord of the appliance.
• Avoid pulling the cord when removing
the plug from the socket. Instead, hold
the plug.
• Do not wind the cord around the
appliance.
• Check regularly that neither the cord
nor plug is damaged and do not use if
there is any damage, or if it has been
dropped on the oor, dropped in water
or damaged in any other way.
• If the appliance, cord or plug have been
damaged, have them inspected and if
necessary repaired by an authorised
repair engineer. Never try to repair the
appliance yourself. Please contact
the store where you bought the
appliance for repairs under guarantee.
Unauthorised repairs or modications
to the appliance will invalidate the
guarantee.
KEY TO MAIN COMPONENTS OF THE
APPLIANCE
1. Cord with plug
2. Hanging loop
3. Ceramic hot plates
USING THE APPLIANCE
1. Fully unroll the cord (1), plug in and
switch the power on.
2. Wait 3-5 minutes until the ceramic
hot plates (3) have reached the
required temperature, before using the
appliance.
3. Use the appliance to set your hair as
desired.
4. Turn off the appliance by removing the
plug from the wall socket.
5. Always allow it to cool completely
before you clean it or put it away.
The appliance can be hanged in the
hanging loop (2).
Styling tips
Brush hair thoroughly before setting. Divide
your hair up into small sections, and deal
with them separately piece by piece as
described below until the desired result
is achieved. Hair should be clean and dry
before using the appliance.
• Start with a lock of hair about 5 cm
wide and close the ceramic plates
around the hair near the scalp. Avoid
touching the scalp with the hot
appliance.
UK