Filter
Top Products
© MARMITEK
4
3. INSTALLATION OF THE IR TRANSMITTER
See figure 1.
1. Insert the supplied power adapter into the power socket
(230V-50Hz) and insert the power plug into the DC
input [E] at the backside of the IR transmitter. Use strictly
the supplied adapter!
2. Place the IR transmitter at a maximum distance of 6
meters form the A/V equipment (DVD player, decoder,
video, stereo, etc.) that you want to operate. Point the
front side (with the Marmitek logo) of the IR transmitter
at the A/V equipment.
Beware: It is important for the proper function of the system that the
antenna wire [G] stays free and does not get covered by the metal cas-
ing of e.g. A/V equipment.
4. INSTALLATION OF THE IR RECEIVER
See figure 3 and 4.
1. Open the IR receiver by sliding down the cover at the backside.
2. Place the 2 additionally supplied AAA 1.5V batteries into the IR receiver.
Be careful about the polarity (+/-). This is indicated at the inside of the IR
receiver. Use strictly non-rechargeable (Alkaline) batteries. Slide the cover
back onto the IR receiver.
3. Place the IR receiver within the range of your remote control (maximum 6
meters). Make sure that the front side (with the Marmitek logo) is facing you.
The IR receiver can be moved freely due to the wireless technology. However,
it is important to place it within the sight and range of your remote control.
Experiment with its position for the best result.
Figure 4
Figure 3
Figure 1
PMXS_80x120_IR_versie.indd 4PMXS_80x120_IR_versie.indd 4 15-11-2007 09:28:0215-11-2007 09:28:02