Lumiscope 1098 Blood Pressure Monitor User Manual


 
Memory Recall
You can recall stored data by pressing the
“Memory Recall” switch at any time, EXCEPT while
taking a measurement.
Up to 42 sets of measurement results can be
stored in memory. Memory cell No. 1 is always
used to store the newest set of results.
When pressing the “Memory Recall” switch, the
memory cell number is displayed. The stored
measurement results (systolic/diastolic blood pres-
sure) are then displayed. The display will show the
memorized pressure and pulse value switching
back and forth.
If the “Memory Recall” switch is pressed again, the
prior measurements are displayed in the order they
were taken.
Memory Clear Function
You may erase one or all records in the memory.
•Press and release MEMORY key to choose the
record that you wish to delete.
•Press and hold the ON/OFF key until the display
shows dEL.
•Delete one record: Press and release the power
key. After three beeps are heard, the record is
completely deleted.
•Delete all records:
1. Press and release the MEMORY key then
the display shows dEL ALL.
2. Press and release the ON/OFF key. After
three beeps are heard, the unit erases all
records.
3. Remove one or both batteries while the
unit is on.
8