• To clean the chewing surfaces, direct the rotating brush head with
light pressure over the chewing surfaces.
• Finally, thoroughly clean the back parts of the molar teeth.
• On completion, press the Off switch
e
.
Note:
This appliance has a two minute timer. After two minutes the appliance
becomes slower, indicating to you that the dental profession recom-
mendation of two minutes has been complied with.
Important!:
In the beginning, it is common that the unfamiliar abrasion leads to
bleeding of the gums. This is normal. Should this continue for more
than two weeks, consult your dentist.
Fitting / removing brush heads
• You can remove the brush head
q
by twisting and pulling it
upwards.
• To replace the brush head
q
use the inverse procedure.
The brush head
q
must engage on being put back in. To avoid
damages, use only original brush heads.
(For replacement brush heads, see the order card)
Cleaning and care
After use, clean the brush heads thoroughly under running water.
For hygienic reasons we recommend that every 2 - 4 weeks you clean
the brush head with standard commercial cleaning fluids for dental
prosthetics.
- 4 -
IB_KH120_E2416_LB4c.qxd 01.02.2008 11:27 Uhr Seite 4