Filter
Top Products
- 5 -
First use
Before taking the appliance into use check to ensure that it is
in a fault-free condition. If it is not, it may not be used.
• Insert the power plug into a wall socket.
• Before the fi rst use, clean the new brush heads 1 with
clear water.
• Place a replacement brush head on the brush holder 2,
open the cover of the charging station 3 and slide the
brush holder 2 in.
• Place the hand element on the charging station 3 so that
it slides onto the spike in the base.
• Allow the hand element to charge up for approx. 14 -
16 hours before using it for the fi rst time. The charging
light 5 on the front of the hand appliance glows red
during the charging process.
• Use the hand element repeatedly, and without charging
the battery, until the performance is noticeably weaker or
the toothbrush stops working and the charge indicator 5
blinks red. First then recharge the battery for 14 - 16 hours.
When the appliance is fully charged, the charge indicator 5
glows green.
• Charge and discharge the toothbrush completely 3 times.
The battery will have then reached its full capacity.
• You can now leave the hand element in the charging
station 3 after every use, so as to always have full power
available.
For care of the batteries, we recommend the following:
When the hand element is fully charged, remove the plug
of the charging station 3 from the mains power socket. First
reinsert the plug into the mains power socket and recharge
the hand element when the movement of the toothbrush is
noticeably weaker or the charge indicator 5 blinks.
IB_KH123_45634_LB6.indd Abs1:5IB_KH123_45634_LB6.indd Abs1:5 14.01.2010 9:16:21 Uhr14.01.2010 9:16:21 Uhr