Filter
Top Products
Technical Information
Fixture*:
Basin area:
Bathing area, bottom 40″ (1270 mm) x 27″ (686 mm)
Bathing area, top 61″ (1549 mm) x 32″ (813 mm)
Weight 165 lbs (75 kg)
To overflow:
Water depth 16″ (406 mm)
Capacity 90 gal (341 L)
* Approximate measurements for comparison only.
Pump: kW V Hz A
1.5 240 50/60 15
Cut-out template 113311-7
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 220-240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Pump/piping protrudes beyond rim (see below).
Maximum deck thickness should not exceed 2″ (50 mm).
Floor support under whirlpool must provide for a minimum of
44 lbs/square foot (214 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
If installing a rim-mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
1-1/2" OD
42"
(1067 mm)
6-1/2"
(165 mm)
2-7/8"
(73 mm)
3"
(76 mm)
3" (76 mm) x 24" (610 mm)
Flat Faucet Deck
2-1/4"
(57 mm)
36"
(914 mm)
72" (1829 mm)
Note: Pump/piping protrudes beyond rim.
Pump/Control Access
34" (864 mm) W x
15" (381 mm) H Min
22"
(559 mm)
3-1/2" (89 mm)
13-1/2"
(343 mm)
1" (25 mm) Max
4" (102 mm) Max
Recommended faucet area.
No change in measurements with drain
shown. (K-7167-AF)
Product Diagram
REVIVAL
®
REVIVAL
®
6’ EXPERIENCE BATH WHIRLPOOL WITH SPA/MASSAGE PACKAGE
Page2of2
1023248-4-
E