Filter
Top Products
Important Information
WARNING: When using electrical products, basic precautions should always be followed, including
the following:
DANGER: Risk of electric shock. Connect only to a circuit protected by a Ground-Fault
Circuit-Interrupter (GFCI).
WARNING: Risk of electric shock. A licensed electrician should make all electrical connections.
WARNING: Risk of electrical shock. Disconnect power before servicing.
WARNING: Risk of injury or property damage. Please read all instructions thoroughly before
beginning installation, including the following requirements.
NOTICE: Follow all local plumbing and electrical codes.
Install to permit access for servicing.
A green lead wire is provided within the wiring compartment. To reduce the risk of electrical shock, connect
this wire to the grounding terminal of your electric service or supply panel with copper wire equivalent in
size to the circuit conductor supplying this equipment.
A pressure wire connector is provided on the exterior of the pump or control within this unit to permit
connection of a bonding conductor between this unit and all other exposed metal in the vicinity, as needed to
comply with local requirements.
Grounding is required. The unit should be installed by a qualified service representative, and grounded.
Building materials and wiring should be routed away from the pump body and other heat-producing
components of the unit.
Important Product Information
Product Notices
WARNING: Unauthorized modification may cause unsafe operation and poor performance of the
effervescent bath. Do not relocate the pump, or make other modifications to the overflowing bath
system, as this could adversely affect the performance and safe operation. Kohler Co. shall not be liable
under its warranty or otherwise for personal injury or damage caused by any such unauthorized
modification.
Product Inspection
Carefully unpack the product, and inspect the unit for damage. Return the unit to the carton during
construction to prevent damage.
NOTICE: Make sure the union connections to the pump and in-line heater are securely tightened. Do
not overtighten.
Factory-Assembled Features
Factory installed components include pump, in-line heater, submerged chromatherapy lights, control and
switch. The pump and piping are factory-assembled.
Connections and Service Access
NOTICE: Provide unrestricted service access to the pump. Provide unrestricted service access to the
pump, in-line heater, and control box. You must construct an access panel to provide sufficient clearance
for servicing the pump, in-line heater, and control box. The access panel must be located immediately next
to the pump and in-line heater. Study the roughing-in information.
1012493-2-A 2 Kohler Co.