Kohler K1191-R Bathroom Aids User Manual


 
13. Using Your Bath
Fill the Bath
NOTE: Please read these steps carefully before you operate your bath.
NOTE: The water temperature in the bath should not exceed 104° F (40° C) or the heater will not operate.
IMPORTANT! Like any other bath, prevent flooding the area around the unit by entering the filled
bathing well slowly. This will allow the system to properly drain excess water.
Fill the unit 4” (10.2cm) to 6” (15.2cm) from the bathing well rim.
Operating Sequence
Press the On/Off control switch to start the pump/motor and begin operation.
A green light in the On/Off control switch will turn on to indicate the start of the operating mode. The
light will remain green while the unit is running.
Verify that the indicator light for the heater is on when the unit is in operation. This indicator light is
located on the underside of the heater box, and is near the subfloor at the pump end of the unit.
If the light is not on when the unit is running, press the reset button located to the right of the indicator
light on the heater box.
Press the “On/Off” control switch again to turn off the bath. The “On/Off” control switch will turn off to
indicate the end of the operating mode.
NOTE: A built-in timer automatically stops the bath after approximately 20 minutes of operation.
Chromatherapy
Lights
1012493-2-A 12 Kohler Co.