Filter
Top Products
INSTRUCTIONS FOR CHARGING YOUR KEN-A-VISION
CORDLESS MICROSCOPE
1. Plug in the round pin adapter from the power supply to the back of
your microscope.
2. Then connect the opposite end to a 110v (220v international)
electrical outlet.
3. With 1 over-night charge you can use your microscope for up to 40 hours
of continuous operation.
4.You do not have to fully discharge or drain the battery to recharge.
TECHNICAL SPECIFICATIONS FOR MODEL NO. T-1201C & T-
1202C
· Power Source Life: 500 Cycles (approximately 4-5 years depending on usage)
· Light Source: “Propietary Light Board” Technology Equivalent to a
20 Watt Bulb
· Power Source: Built-in rechargeable NiMH (Nickel Metal Hydride)
· “Light Board” Life 100,000 Hours
· Cool Operating Temperature Less Than 25°C (75°F)
· 10 year limited warranty on microscope.
EQUIPMENT RATING:
DESCRIPTION OF INPUT OUTPUT CONNECTION
Should you need a replacement power supply, contact Ken-A-Vision or your deal-
er. When using internationally, be sure to use the correct AC voltageeither 110V,
220V, or 240V output voltage (catalog # VFPS230R-2 (230v)or VFPS1209300R
(110v). Output voltage is 9 volt DC 300mA and a 2.5 mmV barreled styled cen-
ter position plug. connection of:
The power supply/charger are made exclusively for the Ken-A-Vision Cordless
Microscopes. Failure to use Ken-A-Vision parts will void the warranty of your
microscope.
Note: This equipment has been tested and found to comply with the limits for
UL Standard 61010A-1.
ENVIRONMENTAL CONDITIONS
This equipment is designed to be safe at least under the following conditions:
· indoor use;
· altitude up to 2 000 m
· temperature 5° to 40°C;
· maximum relative humidity 80% for temperatures up to 31°C
decreasing linearly to 50% relative humidity at 40°C;
· main supply voltage fluctuations not to exceed +/-- 10% of the
nominal voltage;
· transient overvoltages according to installation categories;
· Pollution Degree 2 in accordance with IEC661
Normally non-conductive pollution occurs. Occasionally, however,
a temporary conductivity caused by condensation must be expected.
EQUIPMENT MAINTENANCE
All cordless microscopes should be recharged PRIOR to storage.
The battery type is NIMH (Nickel Metal Hydride) part # VFBATBU2
Should you need a replacement power supply/charger, or battery, contact your
nearest Ken-A-Vision dealer.
INSTRUCTIONS FOR REPLACEMENT OF CHARGER
Remove the connector cable marked battery from the light board. Next
remove the old NIMHbattery and properly discard.
To replace the NIMHbattery simply plug in the cables to the appropriate color
codes as indicated below. Secure the velcro strips to the battery and affix to
the bottom of your microscope.
kav.instcman.cordless.pc.v2
Part# INS-SC50C
CONNECTOR COLOR CODE