Filter
Top Products
8
Hang-Up Hair Dryer
Mounting Instructions
The Kambrook Hang Up Dryer is
designed to mount onto the wall using
the following procedure:
1. Remove wall bracket from unit.
2. Use the wall bracket as a template
to mark position of holes for drilling
close to electrical outlet, away
from bath or vanity basin.
3. Drill three 4.5mm (3/16") holes
and insert the anchor bushings
by tapping lightly with a hammer
until the shoulder of the bushing
rests against the wall.
4. Position wall bracket aligned with
the holes then tighten the two
bottom screws first, then tighten
the top screw.
5. Match the slots on the back of the
mounting base with the hooks of
the bracket.
6. Press into the hooks and slide
down to ensure secure mounting.
7. Plug unit into the nearby electrical
outlet(230-240 volt AC-50Hz).
IMPORTANT: Do not install
where a person in a bath
or shower can reach the
unit on the wall or reach
the hand-held part when
the cord is fully extended.
Operating Your Kambrook Hang-Up Hair Dryer
How To Operate
1. After washing, towel dry hair.
2. Press release buttons to
remove dryer.
3. To start the dryer, press the On
button on the wall mount unit.
4. Slide the control switch to:
LOW position for styling hair
MED position for drying hair
HIGH for fast drying hair
5. To stop the dryer, just hang it into
the mounting base which will
automatically switch the unit OFF
or push the OFF button.
KHH100_IB_A11_FA.indd 8 14/09/11 2:32 PM