Filter
Top Products
SECTION 15—TRANSPORTING
Part No. 1123839 61
SECTION 15—TRANSPORTING
ƽ WARNING
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Transporting the Wheelchair
ƽ WARNING
The weight of the wheelchair without the user and batteries is approximately 82 lbs.
Use proper lifting techniques (lift with your legs) to avoid injury. Extreme caution is
advised when it is necessary to move an unoccupied power wheelchair. ProBasics
recommends using two assistants and making thorough preparations. Make sure to
use ONLY secure, non-detachable parts for hand-hold supports.
NOTE: For this procedure, refer to FIGURE 15.1 on page 62.
Unfolding/Folding the Wheelchair
ƽ WARNING
Keep hands and fingers clear of moving parts to avoid injury.
DO NOT place hand or fingers on the underside of the seat rail when opening or
closing the wheelchair.
DO NOT sit or transfer into the wheelchair unless it is fully open and the seat rails
are fully seated into the side frame H-blocks.
Unfolding
1. Push down on the seat rails until the seat rails are positioned in the seat guides.
2. Assemble the wheelchair by following the instructions in this manual.
Folding
1. Remove the anti-tippers. Refer to Installing/Removing/Adjusting Anti-Tippers on
page 59.
1. Remove the batteries. Refer to Removing/Installing the Battery Boxes
on page 49.
2. Remove the footrests/legrests from the wheelchair. Refer to
Installing/Removing/Using the Footrest/Legrest
on page 33.
3. Remove the battery tray from the wheelchair. Refer to Installing/Removing Battery
Tray on page 50.
4. Lift up on the seat rails of the wheelchair.