Support User Manuals

Invacare Top End XLT Pro Mobility Aid User Manual

Open as PDF

of 76

SECTION 9—OPTIONS

Recumbent Handcycle Series 74 Part No 1114850

Using the Alignment Gauge

NOTE:Forthisprocedure,refertoFIGURE 9.19.

NOTE:Thealignmentgaugeisusedtodeterminetoein/toeout.RefertoDetermining/Adjusting

ToeIn/ToeOutonpage 44formoreinformation.

1. Inflateallpneumatictirestorecommendedtirepressures(listedonthesidewallofthe

tire).

2. Placethehandcycleandalignmentgaugeonaflatsurface.

3. Positionthealignmentgaugeneartherearofthereartires.

4. Loosentheheightadjustmentscrew.

5. Raise/lowerthealignmentbarsothebarisapproximately12inchesfromthe

ground/floor.

6. Tightentheheightadjustmentscrew.

7. Loosenthealignmentscrew.

8. Positionthealignmentgaugebetweentherearofthereartires.

9. Adjustthealignmentbarsothealignmentgaugefitssnuglybetweentherearofthe

reartires.

10. Tightenthealignmentscrewtosecurethealignmentbarpositio n.

11. Positionthealignmentgaugeatthefrontofthereartires.

12. Examinethegauge.Performoneofthefollowing:

A. AlignmentGaugeFitsSnuglyBetweentheFrontoftheRearTires‐Wheelsare

aligned.Notoein/toeoutadjustmentisneeded.

B. ThereisExtraSpaceBetweentheAlignmentGaugeandRearTires‐Thetireshave

atoeoutcondition.RefertoAdjustingToeIn/ToeOutonpage 45.

C. AlignmentGaugeDoesNotFitBetweenRearTires‐Thetireshaveatoein

condition.RefertoAdjustingToeIn/ToeOut

onpage 45.

FIGURE 9.19 Using the Alignment Gauge

Alignment Gauge

Alignment Bar

Height Alignment

Screw

Alignment Screw

Front of Handcycle

Rear Tires

Front Measurement

Rear Measurement

Rear of Handcycle

previous next