Support User Manuals

Invacare XLT Gold Mobility Aid User Manual

Open as PDF

of 76

SECTION 9—OPTIONS

Part No 1114850 71 Recumbent Handcycle Series

Installing the Front Wheel

NOTE:Foreaseofinstallation,securehandcycleframeapproximately6inchesfromthegroundor

seekassistance.

1. Loopthechainoverthefrontwheelsprocket.

2. Positionthefrontwheelsprocketintotheforkslots.

3. Tightentheknobontheoppositesideofthequick‐releaselever.

4. Securethewheeltotheforkwiththequick‐releaselever.

FIGURE 9.17 Removing/Installing the Front Wheel - XLT Gold, XLT Pro and XLT with Speed

Cassette Chain

Assembling/Using/Adjusting the Handcycle Rack

NOTE:Forthisprocedure,refertoFIGURE 9.18onpage72.

Assembling the Handcycle Rack

1. Positionthereceiverwiththebracketfacingup.

2. Positiontherearwheelbarwiththewheelbracketsfacingup.

3. Removethetwolargemountingboltsandlocknutsfromthereceiverandsetaside.

4. Removethetwosmallmountingboltsandlocknutsfromthereceiverbracketandset

aside.

5. Securethewheeltraytothereceiverwiththetwolargemountingboltsandlocknuts.

6. Usingtwosmallmountingboltsandlocknuts,securethereceiverbrackettothewheel

tray.

7. Removethetwomountingboltsandlocknutsfromtherearwheelbarandsetaside.

Chain

Sprocket

Front Wheel

Fork

DETAIL “A” - FRONT

WHEEL QUICK-RELEASE

LEVER

NOTE:QuickReleaseLeverisan

oppositesideofwheel.

Quick-release

Lever

previous next