Filter
Top Products
Battery Chargers and Harnesses
NOTE: Light Duty, 250-S models use a 4 amp. charger #1061411.
Item
Number
Part Number
DescriptionNote
Quantity Per
Package Assembly
1053834 Harness, Wiring, Standard 1 11 D
1070590 Harness, Wiring 1 11 E
1088802-NLA Screw, Phillips Pan Head (6-32 x 1-1/4") 1 22 A
1088801 Washer, Nylon (3/16 x 1/2 x 3/8") 1 23 A
1011980 Screw, Phillips Pan Head (#6-32 x 3/4") 1 24
1095503 Package, Cable Ties (5-5/8" Long) 10 15
P0870X050 Nut, Keps (#6-32) 1 26
P0870X000 Nut, Hex Keps (#4-40) 1 27
7930318 Screw, Phillips Pan Head (#4-40 x 1/2") 25 18
1053837 Bracket, Charger Connector 1 19
1030949 Screw, Hex Head (1/4-20 x 1-1/2") 1 110
1086804 Bracket, Battery Charger Connector 1 111
1087226 Screw, Phillips Pan Head Tap (#4-24 x 3/8") 1 212
7930333 Locknut (1/4-20) 25 113
1095502 Package, Cable Ties (11-1/2" Long) 10 114
1083929 Cable, Charger Extension (24" Long Round Plug) 1 115
1053161 Battery Charger, 8 Amp. 115vac (Off Board)
Dual Mode Round Plug, Lester
1 116 B
1085678-NLA Battery Charger, 8 Amp. 115vac (Off Board)
Dual Mode Round Plug w/ AC Power Line Cord,
Dynamic
1 116
1061411-NLA Battery Charger, 4 Amp. 115vac (Off Board)
Dual Mode Round Plug, Lester
1 116 H
1123249 Battery Charger, 8 Amp. 115vac (Off Board)
Single Mode Round Plug w/ AC Power Line Cord,
CTE Corp.
1 116 I,I1
1089627 Cord, AC Power Line 115vac (2-prong off-board
11'6"L)
1 117
1090357 Wrap, Slit Wire Harness (1/2" O.D.) (36" Long Cut
To Length)
1 118 C
1098892 Fuse, 15 Amp. (Buss ATC-15) 1 119 F
1090117 Fuse, 15 Amp. (Buss Mini ATM-15) 1 119 G
A - Items 2 and 3 changed after 4/14/99. Order Items 2 and 3 together for chairs manufactured before 4/15/99.
B - On 7/18/01 Lester 8AMP battery charger was reinstated.
C - Plastic wire wrap replaced mesh fabric and heat shrink 9/1/99. Part #1090357 can be used for chairs manufactured
before 9/1/99 as well.
D - Sling Seats and Low Back Captain Seat.
E - High Back Captain Seat.
F - Before 4/1/03. Wiring Harnesses (2) required. Charger Extension Cable (1) required.
G - After 3/31/03. Wiring Harnesses (2) required. Charger Extension Cable (2) required.
H - CTE 8 Amp. charger replaced the obsoleted 4 Amp. charger as of 4/1/04.
I - CTE charger introduced 4/1/04. Used on Gel Cell or AGM (Absorbed Glass Mat) batteries. For wet cell batteries refer to the
8 amp. Lester charger.
I1 - CTE charger looks exactly the same as Dynamic’s charger except for the company name that is silk screened on the
narrow side panel, where the charger plug is (hard wired) attached. Serial number starts with 04A00000001.
NOTE:
64
To order call toll free 1-800-333-6900, or www.invacare.com
Form No.
98-289