Invacare Quick Release Caster Mobility Aid User Manual


  Open as PDF
of 2
 
2. Depress the detent pin of the quick release caster
head tube cap and install over the top of the quick
release caster fork stem.
3. Release the detent pin of the quick release caster
head tube cap and pull on the caster fork to make
sure the fork is securely attached to the chair.
4. Reinstall and securely tighten the bolt and locknut
that secure the two (2) spacers and caster onto the
quick release caster fork.
5. Repeat this procedure for the opposite side.
WARNING
There are several configurations of the quick
release caster. If caster fork stem DOES NOT
look like the drawing in FIGURE 2 when in-
stalled, DO NOT USE. Contact Customer Ser-
vice, 1-(800)-333-6900.
NOTE: When removing the quick release casters for
any reason, reinstall the quick release caster head
tube cap onto the fork stem so it can be located eas-
ily for future use.
Caster Fork
Stem
Approximately
1/4-inch
Caster
Head
Tube
Caster Head
Tube Cap
Detent Pin
Caster Head
Tube
Bolt
NOTE: Frame Shown
For Reference Only
FIGURE 2 - INSTFIGURE 2 - INST
FIGURE 2 - INSTFIGURE 2 - INST
FIGURE 2 - INST
ALLING ALLING
ALLING ALLING
ALLING
THE QUICK-RELEASETHE QUICK-RELEASE
THE QUICK-RELEASETHE QUICK-RELEASE
THE QUICK-RELEASE
CC
CC
C
ASTERASTER
ASTERASTER
ASTER
Invacare Corporation www.invacare.com
One Invacare Way
Elyria, Ohio USA
44036-2125
800-333-6900
Technical Support
800-832-4707
Invacare is a registered trademark of Invacare Corporation
© 1999 Invacare Corporation
Form No. 94-150 P/N 1050205 Rev. A (1) - 11/99
 previous