Filter
Top Products
Invacare Scooters 42 Part No. 1090132 Rev F
ARMSPROCEDURE 7
This Procedure Includes the Following:
Armrest Angle Adjustment
Armrest Width Adjustment
Armrest Depth/Height Adjustment
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise, injury or damage may
result.
ARMREST ANGLE ADJUSTMENT
ALL SEATS BUILT AFTER 10/
00 AND CONTOUR
SEATS BUILT BEFORE 10/00
(FIGURE 1)
1. Lift the armrest up.
2. Loosen adjustment locknut.
3. Adjust mounting screw up or down to
the desired arm angle position.
4. Retighten adjustment locknut.
5. To determine the same angle for the
opposite armrest, count the exposed
threads on the socket screw.
6. Repeat STEPS 1-5 for opposite armrest.
ARMREST WIDTH
ADJUSTMENT
ALL MODELS EXCEPT ZOOM-3
(FIGURE 2)
1. Loosen the adjustment knob located
either beneath the seat frame or on
the back of the seat frame.
2. Adjust armrest in or out to the desired
position.
CAUTION
The armrest can be adjusted to a
maximum distance of 4-1/2 inches
between the inside of the armrest
and the mounting shaft the armrest
is inserted into. If the armrest is
adjusted beyond the maximum 4-1/
2 inches, it will fall out.
3. Retighten adjustment knob securely.
4. Measure distance between back and inside of armrest.
5. Repeat STEPS 1-4 for opposite armrest setting armrest at distance determined in
STEP 4.
BACK
Adjustment
Locknut
Mounting
Screw
Armrest
FIGURE 1 - ARMREST ANGLE
ADJUSTMENT - ALL SEATS BUILT
AFTER 10/00 AND CONTOUR
SEATS BUILT BEFORE 10/00
Armrest
MEASURE THIS
DISTANCE
FIGURE 2 - ARMREST WIDTH
ADJUSTMENT
Adjustment Knob
Seat
Frame
NOTE: Only Contour Seat shown for clarity.
Width adjusts in the same manner for Deluxe
Seat.