Filter
Top Products
Battery Boxes, Chargers, Harnesses, and Trays
Item
Number
Part Number
DescriptionNote
Quantity Per
Package Assembly
1089385 Fuse, 80 Amp, MIDI (Non-G/B & G/B) 1 1A,I
1060454-NLA Terminal Harware, U1 Batteries 2 1A,D
A - Not Shown
B - Battery harness fuse changed from a Bussman 60 Amp. to a MIDI 80 Amp. fuse as of 11/5/99 for Dual Battery Boxes and
11/10/00 for the Single Battery Box.
B1 - The current battery box top assemblies are compatible for all chairs manufactured before the dates specified and must
be ordered when a replacement Bussman 60 amp. fuse is requested.
C - On 7/18/01 Lester 8 battery charger was reinstated.
D - Hardware includes small battery terminal caps (gray and orange), 1/4-20 x 7/8" hex flange screws and instruction sheet for
two batteries.
E - It is recommended that new terminal hardware be ordered when a new battery box top is ordered.
F - Before 6/24/98
G - After 6/23/98
H - Before 11/5/99 for dual battery box and Before 11/10/00 for Single battery box
I - After 11/4/99 for dual battery box and After 11/9/00 for single battery box
J - Before 4/1/03. Charger extension cable takes 1 fuse and the wire harness takes 2 fuses
K - After 3/31/03. Charger extension cable takes 2 fuses and the wire harness takes 2 fuses
L - The 4 amp. Lester charger was obsoleted and replaced with the 8 amp. CTE charger. For wet cell batteries, use the 8
amp. dual mode Lester charger.
M - CTE charger introduced 4/1/04. Used on Gel Cell or AGM (Absorbed Glass Mat) batteries. For wet cell batteries refer to
the 8 amp. Lester charger.
M1 - CTE charger looks exactly the same as Dynamic's charger except for the company name that is silk screened on the
narrow side panel, where the charger plug is (hard wired) attached. Serial number starts with 04A00000001.
NOTE:
28
To order call toll free 1-800-333-6900, or www.invacare.com
Form No.
95-167