Filter
Top Products
2
WARNING
DO NOT continue to use this product if any
such problems are discovered. Corrective
maintenance can be performed at or
arranged through your equipment supplier.
MAINTENANCE
These instructions MUST BE followed:
1. Clean weekly with warm water and mild soap
solution. Wipe entire surface with a soft, clean cloth.
2. Visually inspect all parts weekly for deformation,
corrosion, breakage, wear and/or compression.
3. Check hook and loop fasteners for adhesion and
engagement.
FIGURE 1 - ASSEMBLY
Towards The
Front Of Chair
Towards The
Rear Of Chair
Assembly of
hooks for 1-inch
(25mm) drop (use
holes as indicated)
Assembly of
hooks for 2-
inch (50mm)
drop (use holes
as indicated)
Assembly of
hooks for 3-inch
(75mm) drop
(use holes as
indicated)
Drop Base Assembly for
1-inch (25mm), 2-inch (50mm) and 3-
inch (75mm) drop
(use holes as indicated)
Hook And Loop
Faces UP