Filter
Top Products
43
The Invacare® Auriga/Auriga
10
is equipped with an integrated charger. The socket for this charger
is located on the front of the Battery and Motor Compartment Cover (1). To charge the scooter, you
only need to connect it to a mains power supply using the cable supplied with the scooter.
Connecting the scooter to a mains power
supply
• First connect the cable to the scooter.
• Then connect the cable to the mains power
supply and switch on.
Disconnecting the scooter from the mains
power supply
• First disconnect the cable from the mains
power supply.
• Then disconnect the cable from the scooter.
How can I tell when the batteries are fully charged?
Look through the slot for the de-clutching lever (2) down into the motor and battery compartment.
You will see a green LED. This is the charger LED.
LED ACTIVITY CHARGING PHASE
LED lights contantly Start
LED dims and flickers 90% Finished
LED go out / flickers for a few seconds /
goes out again
Finished