Invacare 9680 Bathroom Aids User Manual


 
2
SHOWER CHAIR Part No. 1087196
4. Insert the phillips head screw and flat washer through the top center hole. Thread
through both legs and secure with lock washer and wing nut.
5. Align leg sections with underside of seat while seat is still upside down on ground/floor.
6. Install one (1) slotted hex head screw through the leg tube and into seat. Loosely tighten.
Repeat for remaining three (3) slotted hex head screws.
7. Once all components are assembled, tighten all hardware until a resistance is felt and all
slack is removed. Continue to tighten 1/4 to 1/2 of a turn to securely fasten.
FIGURE 1 - ASSEMBLING THE SHOWER CHAIR
Wing Nut
and Lock
Washer
(STEP 4)
Seat
Cutout
Bottom Leg
Screws
(STEP 5 and 6)
Phillips Head
Screw
(STEP 4)
Slotted Hex
HeadScrew
(STEP 6)
Top Leg
(STEP 3)
Bottom
Leg
Flat Washer
(STEP 4)
NOTE: For models with backs, refer to INSTALLING/REMOVING BACKREST in this
instruction sheet.
INSTALLING/REMOVING THE BACKREST ON MODELS
9681P AND 9681 (FIGURE 2)
NOTE: Refer to the GENERAL WARNINGS in the SAFETY SUMMARY of this instruction sheet.
1. Position backrest in slots provided on seat.
2. Push down on back until backrest is secured.
3. Ensure the compression buttons on the backrest are fully visable through notch on back
of seat before using.
4. To remove backrest, place one (1) knee on the seat.
5. Hold back handles and lift up.