Filter
Top Products
3
Part No. 1061349 WHEELED WALKER ACCESSORIES
INSTALLATION WARNINGS CONTINUED
Always test to see that the walker and attachments are properly and securely
locked in place before using.
Swivel casters should be checked periodically for tightness and damage. If
loose, tighten securely. If damaged, replace immediately.
INSTALLING SWIVEL WHEEL ATTACHMENTS MODEL NO.
6267E (FIGURE 2)
NOTE: Refer to the INSTALLATION WARNINGS in the SAFETY SUMMARY of this instruction sheet.
1. Remove the two (2) existing front leg extensions from the walker by depressing the snap buttons.
NOTE: The front leg extensions will not be reassembled to the walker when using the Swivel Wheel Attachments.
2. Depress the snap button on the walker legs and slide the swivel wheel attachments onto
the front legs of the walker. Ensure that the snap button of each leg fully protrudes through
the desired adjustment hole and legs are adjusted so the walker is level.
INSTALLING REAR BRAKE ACCESSORIES MODEL NO.
6265E (FIGURE 2)
NOTE: Refer to the INSTALLATION WARNINGS in the SAFETY SUMMARY of this instruction sheet.
1. Remove the existing rear leg extensions from the walker by depressing the snap buttons
and sliding the extensions off.
2. Install the 10-inch Rear Wheel Brakes or 10-inch SureGlide
TM
Brakes by depressing the
snap buttons on the rear walker legs and sliding the accessories onto the rear legs.
3. Adjust to the desired adjustment hole on the rear accessories.
4. Ensure that the snap button of each leg fully protrudes through the desired adjustment hole
and legs are adjusted so the walker is level.
FIGURE 2 - INSTALLING SWIVEL WHEEL ATTACHMENTS MODEL NO.
6267E AND REAR BRAKE ACCESSORIES MODEL NO. 6265E
*Quantities are per component.
Rear Wheel
Swivel Wheel Attachment
Front
Rear
Snap Button
ITEM DESCRIPTION QUANTITY*
1. Anti-Rattle 1
2. Adjustable Leg w/Axle Hole 1
3. Crutch Tip 1
4. 3-Inch Wheel 1
1
2
3
4
1
2